Moza FFB Profile Wizard
Describe the feel you want. We'll build the profile for you.
Answer a few questions about your base, aircraft, and how you want the stick to feel. Our Wizard turns that into a ready-to-import Moza Cockpit FFB preset. Remember to Share it back after you've tested it!
NOTE: Prototype — controls are final-draft, not yet connected to profile generationYour setup
Tell us what you're flying and what you're flying it with.
This only matters if we can deliver your finished profile straight into MOZA Cockpit / Axis & Ohs, skipping a manual import. Not confirmed yet — these choices may end up unused.
This picks the baseline preset your answers get layered on top of.
Click and drag anywhere on the dial (right/up = faster, left/down = slower), or click the number and type a value directly. Range shown is a generic default for now — once Aircraft Category drives it, this will narrow to something sensible for what you picked above.
Stick feel
The base physical feel of the stick, before any in-flight effects are layered on.
Turbulence & air feel
How the aircraft talks back to you through the air.
Ground & engine effects
Rumble and vibration cues from the runway, gear, and powerplant.
Trim & centering
How the stick's center point responds as you trim.
Review & export
Check your choices below. Generation isn't wired up yet — this preview shows what the wizard will send once it is.
Show raw control-state preview (developer view)
Both buttons are placeholders — wiring these up to real preset generation is the next phase of this project.




